Gastroback DESIGN JUICER BASIC User Manual Download

Page: 4 / 28

Gastroback recommends safety first

• Do not leave food leftovers dehumidify on
the appliance or units of the appliance. If pulp
dehumidifies on the micro mesh filter it may clog
the fine pores of the micro mesh filter thereby
lessening the effectiveness of the juicer. Remove
such dirt immediately and operate according to the
instructions ´Care and cleaning` before you
continue to proceed.
• Never clean or operate the appliance or units
of the appliance with abrasive or hard sharp-edged
items. Use a nylon brush for cleaning the filter
basket.
• Never clean the motor block in the dishwasher.
• Never use force operating the appliance to
avoid damage of the units of the appliance.
• Do not touch the small cutting blades in the
base of the stainless steel filter basket. Pay attention
not cutting yourself when handling the filter
basket.
• Always make sure the appliance is properly and
completely assembled before connecting to power
outlet and operating. The unit will not turn ‘ON’
unless properly assembled.
• Do not push products into the feed chute with
your fingers or foreign objects. Always use the
food pusher provided.
• Do not let the motor run permanently for longer
then 7 minutes to avoid overheating.
• Do not operate the appliance continuously on
heavy loads for more than 10 seconds. In this
case the appliance is overloaded or the fruit
chunks are too big. Cut the fruit in smaller pieces
and try smaller amounts at one time. To continue
juicing turn the appliance OFF and then ON
again. (None of the recipes in this book are
considered a heavy load.)
• While proceeding Do not push the food pusher
too hard down. Empty the pulp container and juice
jug in time to avoid run-over and splatter which
might causes damages to the appliance. When
proceeding hard or stringily food or if you press
the stamp down too hard the motor could stop
or slow down. In this case turn off the appliance
immediately and pull the plug to avoid overheating.
Operate according to the instructions ´Trouble
shooting guide`.

• Do not use the appliance if it is damaged or
units of the appliance are damaged. Do not use
the appliance if it does not function properly or if
it was excessively loaded. The appliance is like-
ly damaged if the appliance or units of the
appliance show cracks, exorbitant wearing
down, alterations or leaks. It is also likely damaged
if the drive wheel of the motor block moves slowly.
Take the appliance for technical maintenance
and repair to an authorised specialised reparation
shop. Reparation and technical maintenance of
the appliance or line cord are just allowed to be
accomplished by an authorised specialist reparation
shop.
• The appliance is not suitable for mincing nuts,
chocolate or similar ingredients. The appliance
is not suitable to make minced meet or to blend
food.

Important Safeguards for all Electrical
Appliances

• Always uncoil the line cord completely before
installing the appliance.
• Place the appliance close to a power point
and connect it directly without using any extension
cords to avoid additional risks of injury through
fire or voltage.
• Only install the appliance in proper form
secure grounding receptacle with adequate
electric power supply (alternating current;
230/240 V, 50 Hz) and ground fault circuit
interrupter. The maximum power consumption of the
appliance is 450 Watt. You should also install a fuse
with a release current of maximum 30mA. If
necessary ask your electrician for help.
• Never pull, rip, bend, clamp, squish or knot the
line cord. Pay attention to the line cord not
hanging of the table. Attend to nobody getting
caught in loops of the line cord or pulling the
appliance of the work space. When pulling the
plug always catch hold of the enclosure of the plug.
• Do not immerse the motor housing or power
cord in water or any other liquid. Do not pour
or drip any liquids on the motor housing or power
cord. When liquids are spilled on the motor