51
51
which side is facing upwards: coarse or fine. If you can not install the cutting disc in combi-
nation with the separator disc, check whether you use the correct (long) shaft, and whether
you installed the separator disc in the correct orientation.
6. Cover the bowl with the lid for continuous feeding. The protrusion on the lid must fact to
the right side near the handle of the bowl. If necessary, turn the lid a little over the bowl until
the lid settles on the brim of the bowl.
7. Turn the lid clockwise until the safety interlock engages and the protrusion on the lid is
exactly over the handle of the bowl. Ensure that the lid is locked firmly.
8. Pull up the black universal ‘s’ blade of the outlet, until the outlet of the lid is completely
open.
9. Place the food collector under the outlet. One side of the food collector is rounded, so that
it fits exactly to the outer walls of the bowl. Place the food collector with this side as close as
possible to the bowl.
NOTE:
When connecting the appliance to the power supply with the ON/OFF button set to
ON, the motor starts running immediately!
10. Connect the appliance to the power supply. If the motor starts running, press the ON/
OFF button to stop it.
CAUTION:
At the latest, empty the bowl as soon as the maximum filling level (1500 ml) is
reached.
11. Take the pusher out of the feed tube and fill in the food, you have prepared already.
For getting optimal results, it is essential how you stack the food in the feed tube. For this,
some hints are given in section „Tips for Best Results“.
WARNING:
Do not push down your food with your hands! Always use the pusher. Do not
push too vigorously to avoid overloading the motor.
11. While holding the pusher at the food with one hand, switch on the motor with the other
hand. In most cases, it takes only a few seconds to process a filling of the feed tube, and
using the PULSE button for this is more convenient. However, you can switch the motor on
and off via the ON/OFF button.
Tip:
There will always be a small piece of food left unprocessed between the food pusher
and the cutting disc. Generally, there is no need to remove it. Just fill up the feed tube and
continue processing.
CAUTION:
At the latest, empty the food collector and/or bowl as soon as the maximum
filling level (1750 ml for the food collector and 500 ml for the bowl) is reached.
13. If the feed tube is empty, switch OFF the motor and fill the feed tube again with the next
portion. This way, process your food. But doing so, do not overfill bowl and food collector.
WARNING:
The blades of the cutting tools are very sharp. Handle with care to avoid
injuries!
14. If the food in bowl or food collector reaches the maximum filling level, empty bowl and
food collector, before continuing processing. Refer to the instructions in section „After Proces-
sing“, if you are not used to handling the appliance. First switch OFF and unplug the appli-
ance. Remove the food collector from under der outlet. For this, tilt the food collector a little,
ensuring not to spill the contents. Empty the food collector. Remove the bowl from the motor
base and then remove the lid from the bowl. Carefully take out the cutting disc, separator
Summary of Contents for 40963 DesignFood Processor S
Page 27: ......
