49
49
WARNING: The blades of the cutting discs are very sharp. Only grasp the
cutting discs at the brim or at the black central plastic body.
4. For slicing, shredding, and grating you need one of the cutting discs. Select the approp-
riate disc. The cutting discs can be used in two orientations. The processing results depend
on which side is facing upwards: coarse or fine. The discs are assembled with the bowl still
EMPTY and are mounted on top of the shaft, almost level with the brim of the bowl.
5. Cover the bowl with the lid. The protrusion on the lid must face to the right side near the
handle of the bowl. Insert the pin in the middle of the lid in the opening on top of the shaft. If
necessary, turn the lid a little over the bowl until the lid settles on the brim of the bowl.
6. Turn the lid clockwise until the safety interlock engages and the protrusion on the lid is
exactly over the handle of the bowl. Ensure that the lid is locked firmly and will not wobble.
NOTE:
When connecting the appliance to the power supply with the ON/OFF button set to
ON, the motor starts running immediately!
7. Connect the appliance to the power supply. If the motor starts running, press the ON/OFF
button to stop it.
8. Take the pusher out of the feed tube and fill in the food, you have prepared already.
For getting optimal results, it is essential how you stack the food in the feed tube. For this,
some hints are given in section „Tips for Best Results“
WARNING:
Do not push down your food with your hands! Always use the pusher. Do not
push too vigorously to avoid overloading the motor.
9. In most cases it takes only a few seconds to process a filling of the feed tube, and using
the PULSE button for this is more convenient. However, you can switch the motor on and off
via the ON/OFF button.
CAUTION:
At the latest, empty the bowl as soon as the maximum filling level (MAX; 750
ml) is reached.
Tip:
There will always be a small piece of food left unprocessed between the food pusher
and the disc. Generally, there is no need to remove it. Just fill up the feed tube again and
continue processing.
10. If the feed tube is empty, switch OFF the motor and fill the feed tube again with the next
portion. This way, process the desired amount. But doing so, do not overfill the bowl. Always
observe the maximum filling level (MAX).
WARNING:
The blades of the cutting tools are very sharp. Handle with care to avoid
injuries!
11. If the food in the bowl reaches the maximum filling level (MAX), empty the bowl, before
continuing processing. Refer to the instructions in section „After Processing“, if you are not
used to handling the appliance.
First switch OFF and unplug the appliance. Remove the bowl from the motor base and then
remove the lid from the bowl. Take out the cutting disc. Thereafter take out the processed
food using a wooden or plastic spoon.
If you wish to continue processing, replace the cutting disc on the shaft and re-assemble the
lid. Wipe off all spilled liquids or food carefully from the exterior of the bowl. Then, replace
the bowl on the motor base and lock bowl and lid. Thereafter, connect the appliance to the
power supply again and continue working quite usually.
Summary of Contents for 40963 DesignFood Processor S
Page 27: ......
