29
9.
Rinse all parts of the mixing jar in warm detergent solution. Soak the stubborn food
residues on the parts for a few minutes and then remove these with a small plastic brush or
sponge. While doing so be careful not to cut on the sharp blades.
10.
Rinse the parts of the glass jug with clear water and dry the parts afterwards with a
clean cloth gently. Let the parts (especially blades and bottom of the jug) dry in a protected
and inaccessible to small children area at the air. Place the parts back together after drying
(see: ›Assembling the glass jug‹).
Cleaning the Motor block
warning:
Always unplug the power cord before cleaning the motor base. Never pour
water or other liquids on the motor base pour, run into the motor base or under the motor
base. Never immerse the motor base in liquids or place on wet or damp surfaces. Wipe
away spilled liquids immediately. At the bottom of the motor base are vents. Please ensure
that no water can run or drip into these openings.
1.
Unplug the power plug from the outlet.
2.
Then wipe the motor base with a damp, not dripping cloth. Make sure to avoid damaging
the drive wheel and bearing of the drive wheel in the centre of the socket. Never poke with
fixed or hard objects in the mount of the motor base. Use a soft brush if necessary to clean
the mount. If moisture gets into the mount of the motor base, clean and dry the mount very
carefully and thoroughly.
3.
Dry the appliance thoroughly. The entire motor base must be completely dry before you
reassemble the appliance and use.
sTorage
Assemble the glass jug for storage completely and correctly to avoid injury from the blade
and loss of parts. Place the glass jar onto the socket of the motor base. In this way, the
sealing ring, the knives and the drive wheel are protected best against dirt and damage.
warning:
Never place the bottom of the jug or the knives without the glass jar on the
motor base.
important:
Do not let the power cord slide across the floor and make sure that the power
cord does not hang or can be caught.
Store the appliance in a clean and dry place, where it is protected from excessive loads
(impact, shock, dirt, humidity) and inaccessible to small children. Do not place hard or
heavy objects on the appliance. The storage location should be protected from frost and
not be warmer than 40 °C.
TroubleshooTing
The Vital Mixer Basic is reliable and robust and will work smoothly usually when operated
properly. However, should a problem occur, you will able quite easily to eliminate this in
most cases. The following error table is intended to assist.
warning:
Do not attempt to use this appliance for any other than the intended use,
described in these instructions. Maintenance and repair of the appliance must be performed
only by an authorized service centre. Do not use the appliance when it is probably dama-
ged or is not working as expected.
