GasSecure GS01
Hardware Manual
CERTIFICATIONS
31
7.2
Regulatory compliance of radio for GS01
7.2.1
Radio equipment directive (RED)
The GS01 and GS01-EA wireless gas detector complies with the essential
requirements and provisions of RE Directive 2014/53/EU.
7.2.2
FCC compliance
The GS01 and GS01-EA device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
7.3
Marking
The GS01 and GS01-EA detectors are marked with product identification plates
as shown in Figure 7-1 through Figure 7-4. The detectors are in addition marked
with a label for FCC compliance (cf. Figure 7-5). The marking is explained in detail
under the figures.
The antenna delivered with the GS01-EA is also marked with an identification
label, cf. Figure 7-7:
Figure 7-1: GS01 product identification plate