Gaspardo MCE 12000, Use And Assembly Instructions / Spare Parts

Page: 10 / 72

USE AND MAINTENANCE
ENGLISH
24
-
cod. G19502283
5.4.2 HOW TO CHECK SPEED SENSOR FOR FUNCTIONING
"& >
;[ ) X™ ON/OF F>-key), to attend that the
&Š‘‹
5.5 FUNCTIONING MODE
5.5.1 STANDARD USE
& X
ƒ’ŠV ‹ <<[
below.
) Š"‹
2) Using a screwdriver or other metal mass, pass over the red part
speed (which probably will not be constant) it means that the
5.4.3 HOW TO CHECK PHOTOCELLS FOR FUNCTIONING
"& >
=!!^$ˆ|ˆŒ)="!^+ˆ``& Š‘‹-
sed and, while holding this button down, switch on the monitor
ˆ|:ˆ`` XŠ"‹[
“tEst” will appear.
The monitor will run a test that lasts about 2.5 seconds, switching
‰^+ \
Š% <_‹
Also, as soon as it is switched on, it will automatically carry out
‰^+XŠ*‹[ '
“ X ‡ {[
& '
the monitor are those that should actually be sowing, because the
&
In the non-recognized rows, the sowing control will not be carried
X Š‹[ X '
and non-recognized) can always supply battery voltage to the
their connector contact, as they are non-electronically managed.
= &
* & &
working parameters, such as the seed planting distance (
d ) to which
the seed drill is set, inter-row width ( L ), sowing control sensitivity
( S ), understood as the tolerance allowed on seeding variability
(expressed in percentage; the higher the set value, the less rigo-
[ X
C ) read by the
speed sensor over a hundred metres covered (see Programmable
Parameters paragraph).
During the work, the monitor compares the seed planting distance
set in parameter (d) with the one calculated through the data coming
X [
in one or more rows not being the same, also taking into account
the set sensitivity (parameter
S ), the monitor will report this as
described in the next paragraph.
SEEDER MONITOR
MCE 6000-12000 starts the stored row control phase.
&
XŠ)‹[‰^+=
‰^+ “
“
&
‰^+
-
table, gradually increase the sensitivity number (parameter “S”)
‰^+
C
C J
- Simulated test :
#
”;\
correctly it will send pulses to the monitor, which will emit an
‰^+
is connected.
= #
photocell: the LED will go out and the sound will also stop.
Repeat the test with the next photocell.
N.B. : N.B.: between one test and the next, it is important to wait
‰^+
Execute this operation on each photocell.
- Real test :
(
\
(