TEST FIRING HEATER
Test fire heater, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles indicate gas
leakage.
DO NOT
use a match to test for gas leaks.
WARNING:
White smoke may appear around the radiant head during the first minute of the initial firing.
TROUBLE SHOOTING
Problem
Possible Causes
Main burner won’t light
• No gas
• Low gas pressure
• Blockage in orifice
Note:
If the appliance cannot be adjusted to perform correctly it should not be used until serviced or repaired.
Warning:
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
Any modifications or adjustments made to product without prior authority from the manufacturer will void any warranty claims.
Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment.
LIGHTING INSTRUCTIONS
Warning: White smoke may appear around the radiant
head during the first minutes of the initial firing.
Step 1.
Connect the hose and regulator and open the cylinder valve.
Step 2.
Firmly pull the ignition cord and keep it depressed.
Step 3.
Check for flame at the burner. If burner does not light
try again. Several attempts may be necessary.
Step 4.
With the burner alight keep cord depressed for 15 seconds.
Step 5.
To turn heater off, pull the OFF cord. Several attempts
may be necessary.
