3
7.
The hose must be protected from contact with
hot or sharp surfaces both during use and while
in storage. The hose assembly should be visually
inspected prior to each use of the heater. If
excessive abrasion or wear is evident, or the hose
is cut, it must be replaced prior to operating the
heater. The replacement hose assembly may be
obtained from the manufacturer.
8.
DO NOT use any pressure regulator or hose
assembly other than those supplied with the
appliance. Replacement pressure regulator
and hose assembly must be those specified.
Replacement parts maybe obtained from the
manufacturer or your local sales
representative.
9. Installation and use of this heater must conform with
local codes and AS/NZS 5601.
10. This heater is designed to operate with a standard
9Kg propane cylinder with Approved Cylinder
Connection.
11. The valve outlet must be maintained in good
condition. When the cylinder is not in use, be sure
to cover it with a dust cap. A leak test should be
performed with soapy water whenever connecting a
new cylinder.
NEVER use a match to test for leaks.
12. The propane cylinder must be turned off whenever
the heater is not in use. When the heater is to be
stored indoors, the propane cylinder and the heater
must be disconnected and the cylinder stored in
accordance with the Standard for Storage and
Handling of Liquefied Gases.
13. The appliance has been designed with several
safety features which include a tip over switch.
NOTE: The plastic container in the base must
be filled with sand before use.
IMPORTANT
Storage of an appliance indoors with the cylinder
attached is only permitted if the size of the cylinder
complies with AS/NZS 1596; otherwise cylinders
must be stored outdoors in a well ventilated area.
The guards are fitted to this appliance to reduce the
risk of fire or injury from burns and no part of it should
be removed.
This appliance must be protected from exposure to
rain.
Any modification to the heater not described in the
installation instructions may compromise the safety of
this appliance. Special concern is as follows:
(1)
DO NOT shorten post length;
(2)
DO NOT bypass thermocouple safety;
(3)
DO NOT operate heater without a reflector;
Clothing or other flammable materials should not be
hung from the heater, or placed on or near the heater.
The area above the burner may be extremely hot. Direct
contact with these metal surfaces should be avoided in
order to prevent burns or clothing ignition.
Screw the coupling nut of regulator into the cylinder valve
outlet.
POL CYLINDER CONNECTION DEVICE
Type of Gas
Propane
Consumption
40 MJ/h
Operating Pressure
2.75 kPa
Injector Size
1.90 mm
Heater specifications can be found on the data label.
Model Number
Colour
PH2260
Charcoal
Powdercoat
PH2269
Stainless Steel
