HEATER ASSEMBLY
NOTE:
Recommended clearances
must
be maintained for ALL configurations.
TOOLS REQUIRED:
Drill
10mm masonary drill bit
Adjustable spanner
Phillips head screwdriver
STEP 1.
Firmly attach the base plate using the three
expanding fasteners to a concrete footing OR
alternatively for NGW45 to a rigid pillar, wall or
ceiling using four expanding fasteners.
STEP 2.
a. Fasten the elbow fitting to the end of the
gas pipe.
b. Attach the other end of the gas pipe to the
inlet of the heater head. Ensure that the
fitting within the head is braced/held when
tightening pipe.
c. Slide the protective cover onto the post.
OR alternatively for NGW45 connect
an AGA certified stainless steel braided
hose to the head, feeding it through
the required post assembly. Where a hose
assembly is to be used to connect an appliance it
must comply with AS5601-2004 Gas Installations
pipe sizing tables and shall not exceed 3 metres
in length. The internal diameter of the hose
must not be less than 15mm.
STEP 3.
a. Slide assembled gas pipe and heater head
into post.
b. Turn heater head so elbow fitting lines up
with opening at the bottom of the post.
c. Secure the heater head, then attach to the
post using three M5 screws 8mm long OR
for NGH45 attach the head to the existing
post ensuring that the securing of the
head to the support pole is adequate.
STEP 4.
Fasten the post to heater base using the eight M6 x
10mm screws provided.
NOTE:
NGH45 is designed to fit a 50mm diameter
pole.
STEP 5.
Attach the natural gas regulator between the manual
shut off valve of the supply line and the heater gas
hose or pipe.