9
TEST FIRING HEATER
Test fire heater, following the lighting instructions.
Leak test all gas connections with soapy water.
Soap bubbles indicate gas leakage. DO NOT use a
match to test for gas leaks.
Warning: White smoke may appear during the first
minute of the initial firing.
Note: If the appliance cannot be adjusted to
perform correctly it should not be used until
serviced or repaired.
TROUBLE SHOOTING
Problem
Possible causes
Appliance
won’t light
No gas
Low gas pressure
Blockage in orifice
Manual valve not in ‘LOW’ or
‘HIGH’ position
Warning: Improper installation, adjustment,
alteration, service or maintenance can cause
injury or property damage.
Any modifications or adjustments made to product
without prior authority from the manufacturer will
void any warranty claims. Read the installation,
operating and maintenance instructions thoroughly
before installing or servicing this equipment.
LIGHTING INSTRUcTIONS
Step 1
Ensure that the control knob is off. Slowly open
the gas cylinder valve.
Step 2
Push in control knob and turn anti-clockwise to
ignite. Hold knob in, a pulsating sound will be
heard, watch for the pilot to light.
Step 3
If pilot does not light immediately turn control
knob to ‘OFF’ position and try again from the start.
Allow 3 minutes between ignition
attempts for gas to dissipate. Several attempts
may be necessary.
Step 4
For maximum heat push in and turn the control
knob to ‘HIGH’.
Step 5
For minimum heat push in and turn the control
knob to ‘LOW’.
Step 6
To turn heater off, turn the control knob to ‘OFF’,
then turn the gas cylinder valve off.
