2
3
Gas Installation Codes
• Appliances must be used in accordance with the
installation requirements of your gas supply
authority, or the Australian Standard
AS/NZS 5601.
• Appliances for use with bottled gas are labelled
‘propane gas’.
Clearances
Minimum Clearances from combustible materials
must be:
Rear - 300mm Sides - 300mm Above - 300mm
Hose & Regulator Safety
The regulator and hose assembly supplied with the
appliance are suitable for propane gas only.
A gas regulator adjusted to have an outlet
pressure of 2.75kPA is supplied for connection to
the propane gas cylinder. The pressure regulator
and hose assembly supplied with the appliance
must be used. Replacement pressure regulators
and hose assemblies must be those specified by
the appliance manufacturer.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting or kinking of the flexible hose.
After the assembly has been secured, turn on the
gas and check for leaks by brushing a soap and
water solution over all connections.
If you are unable to correct the leak by tightening
the connections, turn off the gas and contact the
supplier immediately.
Always ensure the appliance is kept away from
flammable materials and the gas cylinder clear
of any heat source. When changing over from
an empty gas cylinder to a full one make sure
this procedure is carried out in a flame free
atmosphere.
Specifications
Specifications can be found on the data label
attached to the body. Hose connection thread is
5/8 -18” UNF.
GENERAL INFORMATION
Section
Page
General information
3
Warnings
4
Assembly and lighting procedure
5
Operating procedure
6
Care and maintenance
7
BBQ components and assembly
8
Safe locations
10
Warranty
11
CONTENTS
