-8-
6. RECEIPT AND START-UP
6.1 Receipt
When you receive the machine, you must first check that it is in perfect conditions, without any
damage, dents or knocks.
If there is any problem, we advise you to notify the distributor or INDUSTRIAS GASER S.L. directly.
6.2 Start-up
1.
This machine basically comprises the following parts: the chassis, the blades, the eccentrics
and the crank
2.
It is important that when you start to portion the product, the machine is completely clean to
ensure its correct functioning.
3.
Depending on the length of the product to be prepared, the corresponding pair of eccentrics
will be used (Pos. 2 overview).
3.1.
To change the eccentrics, loosen the 5 blade assemblies (page 16) using the knurled nuts
(Pos. 14 overview) and move them to the edge of the rotating plate (Pos. 1 overview) using the
slots. Remove the eccentric fixing knob (Pos. 7 overview) and replace the eccentrics.
Photo 1. Loosen the nuts and slide the
blades out of the way.
Photo 2. Remove the knob.
Photo 3. Remove the eccentrics.
3.2.
To fit the eccentrics, tighten the eccentric fixing knob again. Take special care when
putting the blades back in place as the blades must be positioned according to the grooves on the
back face of the rotating plate. Each of these grooves corresponds to a 20 mm increase in the
length of the product. Note that when adjusting the blades, they must
close completely
when
passing over the widest point of the eccentric (Photos 6.1 and 6.2)