Page 7-30
MDE-4334C Atlas Start-up and Service Manual · April 2008
Hydraulic/Mechanical Components
Meters
9
Bolt the meter to the inlet and discharge flanges.
10
Bolt the meter to mounting brackets.
11
Replace the pulser drive or computer drive.
After Repairing Meters
After the repair is complete, proceed as follows:
1
Open shear valves (dispensers only).
2
Restore power to the unit and STP. In the D-Box, place the unit in normal operation.
3
Purge air and check for leaks. See
.
4
Calibrate the meter.
Replacing Cylinder Cover and Gasket (Cylinder Cover Leaks)
Note: Cork gaskets may show some staining. Replace gaskets only when you note dampness
or pooling of fuel.
To replace the cylinder cover and gasket, proceed as follows:
1
Follow steps
in
2
Remove the cylinder cover.
3
Scrape the old gasket and clean the surface.
4
Install the new gasket. Replace the cylinder cover.
5
Torque all bolts in sequence, as shown below.
Figure 7-14: Replacing Cylinder Cover and Gasket
1st
2nd
3rd
4th
5th
6th
Cylinder Cover Gasket
Cylinder Cover
6
Follow the steps in
.