-
44
-
(H)
(G)
(I)
5. Before replacing the oil filter, make sure that the spring
(F)
and
the o-ring
(E)
are in the correct position.
6. Position the filter cover and bolt it down, without surpassing the
recommended torque value.
7. Inspect the oil filter intake. To do this, remove the oil filter intake
plug
(G)
, clean the filter and check the o-rings- Remount the filter
and tighten the plug.
8.
Remount the crankcase plug and tighten it. Add approximately
1,000 ml of new oil through the opening in the ignition cover
(H)
.
WARNING
The engine may be damaged if the oil is not used properly or the
specifications recommended by GAS GAS MOTOS are not followed.
Use the type of oil specified in the section on Petrol and Oil
recommendations.
9. Start the engine and allow it to run some minutes. Check for oil
leaking from the filter cover. Stop the engine.
10. Check that the oil level is correct: Place the motorbike on a
horizontal surface and verify that the oil covers the window
(I)
.
11. If more oil is needed it can be topped up through the opening in
the ignition cover
(H)
.
