GAS GAS Enduro 2T 250 2018, Owner'S Manual

Page: 27 / 77

Owner's Manual
-27-
Breaking-in
it is important to carry out the breaking-in phase, by doing this you will ensure the
duration and correct function of your engine in the long term. The intervals to be
performed are the following:
1. from 0 to 200 km: Riding at between 50% and 75% load (throttle opening),
alternately, without continued use at 75% load.
2. from 200 to 300 km: Riding the same but reaching on occasion, without
keeping it more than 5 ~ 10 seconds, at 100% load.
3. from 300 to 400 km: Riding a 75% to 100% load, alternatively, without
maintaining the load stop.
4. from 400 km, increase the requirement with some escalation around 60 ~ 80
km, until reaching its full performance.
DanGer
Reckless acceleration can cause problems in the engine. Take care that you use
the skills and techniques necessary in riding the motorcycle.
Starting procedure
To start your gas gas with the kick-starter follow the following steps:
1. open the fuel tank tap.
2. Release the kick-starter.
3. give two strong fuel strokes.
4. Engage the choke lever (1).
5. operate the kick-starter vigorously.
note: With the engine at operating temperature it is not necessary to use the
choke lever.
To start your gas gas with the electric starter perform the following steps:
1. open the fuel tank tap.
2. Turn the ignition key (2).
3. give two strong fuel strokes.
4. Engage the choke lever (1).
5. Engage the clutch lever.
6. press the start button.
note: With the engine at operating temperature it is not necessary to use the
choke lever.
1