Engine Assembly
142
INPUT DRIVE GEAR
After fitting the linchpin, attach the input drive
gear (1) by holding the alternator rotor with the
17-mm spanner and by tightening the nut on the
input drive gear at the specified torque.
Input drive-gear nut
110 Nm (11 Kgf-m)
OIL PUMP
Before fitting the oil pump, apply motor oil to the
sliding surfaces of the pump housing, the outer
rotor, the inner rotor, and the shaft.
When fitting the inner rotor, align it with the groove.
Apply a small amount of LOCTITE to the threaded
areas of the screws securing the oil pump, and
tighten them firmly.
When fitting the oil-pump driven gear, align it with
the groove.
1
