Engine Assembly
141
STARTER CLUTCH AND
ALTERNATOR ROTOR
Remove the grease from the tapered area of the
crankcase and the alternator rotor.
Fit the linchpin (1) and the alternator rotor (2).
Use a 17-mm spanner to tighten the alternator-
rotor nut at the specified torque.
Alternator-rotor nut:
100 Nm (10 Kgf-m)
ROCKER SHAFT
1) Rocker or vibration-absorbant shaft
2) Bearing
3) Rocker-shaft driven gear
4) Washer
5) Water-pump retainer
6) Water-pump turbine
7) Washer
A) Rocker-shaft nut
When fitting the drive gear to the rocker shaft,
align the pin with the groove.
Attach the rocker-shaft driven gear by aligning
the matching marks.
Tighten the rocker-shaft screw at the specified
torque.
Compensating-shaft screw: 10 Nm (1 Kgf-m
1
2
3
4
4
5
6
7
A
1
Element
Nm
Kgf-m
A
10
1
2
