Engine
200 cc / 250 cc / 300 cc
EC ENDUCROSS WORKSHOP MANUAL
Ed: 07/05
SERVICE AND REPAIR OF THE ENGINE COMPONENTS
04-11
crankcase housing.
- Check the opening for lubricating the crankshaft bearing
-arrow-. It should be free of obstruction and clean.
Right half crankcase, outer side
- Take out the right crankcase seals using a seal extractor or
by carefully levering with a screwdriver.
- Place the right half crankcase on a heating plate and heat
to approximately 150 ºC.
Warning:
Be careful when removing and fitting the
needle bearings so as not to put too much
pressure on the bearing housings. If too much
pressure is applied, the crankcase could be
damaged!
!
Note:
To remove the bearings of the right half
crankcase it should be heated to approximately
150 ºC using a heating plate, oven or similar.
When it is hot, only a standard extractor tool
is required, a soft metal or wooden rod, to
completely remove the bearings. In exceptional
cases it may be necessary to use a press to
dislodge the bearings.
i
Note:
All gaskets, seals and O-rings should be
replaced whenever the engine is dismounted
partially or completely.
i
Summary of Contents for EC 200
Page 2: ......
Page 4: ......
Page 69: ...Engine 200 cc 250 cc 300 cc EC ENDUCROSS WORKSHOP MANUAL Ed 07 05 ELECTRICAL SCHEMAS 06 01...
Page 70: ......
