GAS GAS 2009 EC 200 2T, Owner'S Manual

Page: 95 / 107

Owner’s manual
-95-
Footpegs Settings (Only EC Racing models)
FOOTPEGS HEIGHT SETTING
Your GAS GAS EC Racing has height adjustable footpegs to suit your needs, in
particular has two positions.
Position 1 is the standard regulation that is delivered with your motorcycle.
Position 2 gets lower the height of the footpegs at 12mm.
To modify the position of the footpegs, follow these steps:
Position 1 (Standard)
1 2 3
1. Release the cotter pin (4) and remove the washer (5) in order to
remove the bolt (2).
2. Remove the bolt (2) while the other hand holds the footpeg (7) and spring
(6)
3. Loosen and remove the two screws to the frame (3)
4. Fit the part (1) with the orientation shown in the picture, the bolt hole
should be at the top.
5. Retighten the screws to the frame using threadlocker (3).
6. While holding the footpeg (7) Place the spring (6) within the window and
align with the hole to insert the bolt (2), requires some pressure in the
footpeg.
7. Place the washer (5) and insert the cotter pin (4) then open the ends.
4 5 6 7
Position 2 (Height -12mm)
1 2 3
1. Release the cotter pin (4) and remove the washer (5) in order to
remove the bolt (2).
2. Remove the bolt (2) while the other hand holds the footpeg (7) and spring
(6)
3. Loosen and remove the two screws to the frame (3)
4. Fit the part (1) with the orientation shown in the picture, the bolt hole
should be at the bottom.
5. Retighten the screws to the frame using threadlocker (3).
6. While holding the footpeg (7) Place the spring (6) within the window and
align with the hole to insert the bolt (2), requires some pressure in the
footpeg.
7. Place the washer (5) and insert the cotter pin (4) then open the ends.
4 5 6 7