GAS GAS 2006 PAMPERA 400, User Manual

Page: 59 / 70

NOTE
This is not an exhaustive list, it is meant simply as a rough guide to assist troubleshooting for some of the more common difficulties.
FAULT DIAGNOSIS
FAULT
CAUSE SOLUTION
1 The starter motor does not
work
The engine does not rotate
Engine rotates but does not
start
- The fuse for the starter relay is blown.
- Battery discharged.
- Low temperature.
- Crankshaft locked .
- Cylinder/ piston/ crankpin journal seizure.
- Transmission assembly seizure.
- Fuel supply incorrect.
- The motorcycle has been out of operation
for a longer period of time.
- Spark plug soiled or humid.
- Engine flooded.
- Remove the number plate on the left hand side and the
air filter cover then change the starter motor fuse.
- Recharge the battery and investigate the causes for
discharging, visit a qualified workshop.
- Start engine with start pedal.- Crankshaft locked.
- Go to a specialist workshop.
- Go to a specialist workshop.
- Go to a specialist workshop.
- Check fuel tap for breaks or blockages.
- It is advisable to drain the old fuel from the tank.
- When the fuel tank is filled with new flammable fuel the
engine starts immediately.
- Dry the spark plug out or replace it.
- To «unflood» the engine, full throttle, then operate the kick-
start 5 to 10 times or operate the electric starter.
twice in 5 seconds. Then start the engine as described
below. If the engine does not start,
undo the spark plug and dry it.
- Remove the seat and the fuel tank, clean the pin connector
and treat it using a contact spray.
1
2
3
-
57
-