Garudan GF-3131-447 MH, User Manual

Page: 9 / 64

© ANITA
MP03100EN_180912 9
6. INSTALLATIONS OF THE KNEE CONTROL DEVICES

Turn the presser foot lift spanner (1), to let the presser foot (1) down totally. See Fig.3.
 Release the screw (3).

Tighten the screw (6), and adjust the knee control limited frame, make it turn 2mm.

Tighten the screw (3), Release the screw (7).

Turn the screw (8), and make the distance between the end of the screw and the limited frame is
8 mm.
 By turning the screw (8), and operating the knee control block, it can adjust the distance
between bottom of the presser foot and needle plate within 13 mm.

Finish the adjustment, then tighten the screw (7).
7. INSTALLATION OF THE HEAD
 Insert knee control to lift the top bar (1). See Fig.4.

Put the two cover chains (2) into the two table holes.

The chains hookup the bushes on the table. Put the head into the table groove stably.

Insert the head support bar (5) into the hole.
Remarks:
Make sure to insert the head support bar into the hole.
Suppose the support bar doesn't reach the lowest place, it will be dangerous when put the machine.
And the machine may topple and fall.
Figure 3
Figure 4
www.garudan.cz