CH AP TE R 2 - INS T ALL ATIO N
Page 24
(that is, with I/O connections on the “wire side” of the rack).
•
A pair of 1.5” brackets for mounting on a panel.
•
A DIN-Rail mounting
bracket.
2.3.1.1
Mounting in a 19” Rail System
The DX device can be mounted in a 19” rail system with the I/O connectors on the aisle side and the power
and ground connectors on the wire side (conventional mounting) or in the reverse configuration.
Figure 2-1 - Top View: 19” Rail Conventional and Reverse Mounting
Conventional Mounting
The brackets for mounting in a 19-inch rail system attach with two screws to the screw holes
located toward the front of the DX (see
Figure 1-4
). You can adjust the depth of the device
within the mounting system to four positions:
•
By your selection of which pair of screw holes on the short side of the
bracket (that is, the side that attaches to the DX940) to use.
•
By setting the long side of the bracket (that is, the side that attaches to the
rail system) toward the front of the DX940 or toward the rear.
