Magnum 6K8-Series Industrial Field Switch Installation and User Guide 03/06)
34
www GarrettCom com
.
.
Once opened all the four retaining screws the
front cover can be removed easily as shown in Fig
3.6.1d. on the left.
Figure 3.6.1d: Removing Face Plate
Carefully remove the PM screen plate
using finger or small screw driver to
come out easily as shown in Fig
3.6.1d on the right. Just be careful on
the LEDs placed both side and hold
the face plate tightly. There are no
screws used on holding the screen
face plate
.
Figure 3.6.1d: Removing
PM screen Plate
3.6.2
Installing 6KPM Cards in the Magnum 6K8-Series
Only one front-mounted 6KPMV Module may be installed in one Magnum
6K8-Series Field Switch unit. Follow these steps to install a 6KPMV.
Step 1.
Remove top chassis cover. See procedure in Section 3.6.1 above.
Fig 3.6.2a A Magnum 6K8 unit with main board(motherboard) only
Step 2.
Place
Granddaughter
board (as shown in fig. 3.6.2b)
on the chassis built in stand off
(female) provided at the front of
the 6K8-Series Main Board. To
place the Granddaughter board
on the chassis, as shown in
