16
MAGNASCANNER PD 6500
OWNER’S MANUAL
©2000 GARRETT METAL DETECTORS, INC.
6/19/00
PN 1531100
5.11.
ALTER SUPERVISOR ADJUSTMENTS
(
+ TO ALTER CODE1
)
The Supervisor Adjustments code (referred to as
CODE1
) is factory preset to 1234. To
change it:
1
. Press
the
+
touchpad.
2
. Enter a new four-digit code.
3
. When the LCD prompts,
REPEAT CODE
, re-enter the new four-digit code. The mes-
sage,
CODE ENTERED OK,
should appear. (If the message,
INVALID ENTRY,
appears, repeat steps 2 and 3.)
Press
ACCESS
for the next adjustment or
OPERATE
to resume normal operation.
5.12.
ALTER INSTALLATION ADJUSTMENTS
(
+ TO ALTER CODE2
)
The Installation Adjustments code (referred to as
CODE2
) is factory preset to 5678. To
change it:
1
. Press the
+
touchpad.
2
. Enter a new four-digit code.
3
. When the LCD prompts,
REPEAT CODE
, re-enter the new four-digit code. The mes-
sage,
CODE ENTERED OK,
should appear. (If the message,
INVALID ENTRY,
appears
, repeat steps 2 and 3.)
NOTE
: To revert to factory settings:
1
. Open the main cover of the detection unit.
2
. Remove the three screws attached to the controller module cover.
3
. With power turned on and the unit in Operate mode, press and hold the
ACCESS
CODE RESET
button (on the left side of the circuit board) for five seconds. (See
Figure 10-1.)
4
. The codes for the Supervisor Adjustments and Installation Adjustments modes
should revert to
1234
and
5678
respectively.
Press
OPERATE
to exit the Installation Adjustments mode and resume normal
operation. (If
ACCESS
is pressed, the Installation Adjustments cycle starts over,
beginning with the prompt,
RX BALANCE.
)
Special Note
For added security, both access codes should be changed from the factory settings and
revealed only to those who use them. Record the new access codes on the access settings
card that accompanies this manual. Codes should be changed periodically, especially when
changes in personnel occur.
