PD 6500
i
User MANUAL
44
© 2008 Garrett Metal Detectors
PN 1532010 REV F1
6.3
rePAIr
The PD
6500
i
s modular design facilitates assembly and maintenance.
If problems are site-related, see Section 2.1 or contact the factory for assistance. Often
adjusting or relocating the equipment, or removing nearby objects resolves problems.
If the equipment does not perform properly, contact the factory for assistance.
6.3.1
CONTrOLLer MODULe
The controller module, located in the overhead panel, contains all of the circuit boards
required for operation. The cables that connect the controller module to the side panels
are plugged into connectors at the top of each panel. The controller module cover should
not be removed except to:
• Connect wires to remote alarm relays or synchronization circuitry (see Section 7);
• Attach the battery pack module. (see Section 8.1);
• Revert access codes to factory setting (see Section 3.6.);
• Attach remote console or CMA Interface Module.
• Perform a repair.
6.3.2
POWer MODULe
The power module supplies the power required for operation. Ensure that the power cord
is plugged into the connector on the lower left side of the module.
