GARO LS3, Manual

Page: 30 / 65

MANUAL FOR CHARGING POLE LS3
Page
Function indicator lights, RFID operation
With 1 socket installed:
the light is on the left-hand side
With 2 sockets installed:
the lights are on both the left- and right-hand sides
Green steady light Ready to charge.
Blue steady light Charger connected to vehicle.
Red steady light Fault. Reset safety switch/residual current
device/supply fuse.
Yellow steady light Reconnect cable.
White steady light
Socket not activated. Contact operator.
No light at all Check the control fuse for the controller card
or the supply fuse.
If this is switched on, contact certified operator
(see GARO's website, www.garo.se).
RFID function
1. Connect the cable to the vehicle. Green light flashes 2-3 times.
2. Hold the tag in front of the reader.
3. Yellow flashing light: the pole is reading the tag ID.
4. 3 blue flashes. Charging starts. Then steady blue light.
Red flashing light: RFID not approved
RFID is deactivated on delivery. For activation, contact certified operator
(see GARO's website, www.garo.se). The sockets are active until RFID is
activated.
Engine lock for sockets
NB: Blue and white cables from
engine lock not used.
Control fuse for controller card