GARO LS3, Manual

Page: 26 / 65

MANUAL FOR CHARGING POLE LS3
Page 6
N
L
1
L
2
L
3
USB
Packning
Charging pole with plastic anchor or base plate
4 Connect the supply cable.
NB: Max. 2 x 16 mm² Cu
cable fits in the tube
400V charging sockets must
be preceded by a residual cur-
rent device (RCD) type B (part
no. 107502) that is mounted
in the cover or in the supply
distribution board
5 Install the front profile by
pushing it down from above
in the rear profile. Tighten
the two screws in the lower
end of the profile.
6 Mount the seal on the top edge of the profile. Hook the cover
on the rear profile using the 2 hooks.
Connect the device to the appropriate male/female connector
or, if marked with numbers, connect them appropriately