5 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
5
Remove the screws from the left and right
bottom corners and pull the HVAC panel
from the bottom up and away from the
dash.
Gently pull the top section back and away from the dash to
release the top clips. Make sure that the vehicle is off and
disconnect all the harnesses from the back of the HVAC panel.
DO NOT turn the key or push the push to start button until
after the HVAC panel has been plugged back in during later
steps.
Remove the screws on the bottom left and
right that holds the monitor trim in place.
These screws were hidden by the HVAC
panel.
Pull the monitor shroud up and back towards the rear of
the vehicle and remove it. The ribbon cable attached to
the shroud should have already been removed in step 6.
7
Remove the two screws holding the top of
the radio bracket and the bottom of the
monitor brackets.
Using a long Phillips screwdriver, remove the two screws holding
the bottom of the radio bracket. You may need the magnet to
retrieve these screws if they drop inside the dash.
9
6
8
10
