![Garmin GTR 200B Installation Manual Download Page 32](http://html1.mh-extra.com/html/garmin/gtr-200b/gtr-200b_installation-manual_3748142032.webp)
190-01553-00
GTR 200/200B Installation Manual
Rev. P
Page 3-11
3.6.4.5 Discrete Setup Page
The Discrete Setup page (Figure 3-9) allows the installer to configure the operation of the discrete inputs
per the options listed in Table 3-7. It is not necessary to connect the discrete inputs, if a discrete input is
used it is normally connected to a momentary contact pushbutton.
Refer to
Section 3.6.4
to select the Discrete Setup Page. Use the LARGE Knob to scroll through the listed
functions, then use the SMALL Knob to adjust the setting of the function. After the setting has been
changed, turn the LARGE Knob to move the cursor to another function. Note that both discrete inputs
cannot select the same function (except Disabled). For testing purposes, an “X” will appear in the DISC 1
and/or the DISC 2 checkbox when the input(s) are active (see
Section 3.6.5.5)
.
Figure 3-9 Discrete Setup Page
Table 3-7 Discrete Setup Page Selections
Selection
Description
DISABLED
Discrete input is disabled.
PILOT ICS KEY
Discrete input activates the pilot ICS function. Auto squelch and manual
squelch are overridden when the PILOT ICS KEY is asserted.
COPILOT ICS KEY
Discrete input activates the copilot ICS function. Auto squelch and
manual squelch are overridden by COPILOT ICS KEY selection.
FREQ SWAP BTN
Discrete input activates the frequency swap function (a beep tone is
sounded). When held active for one second, the active frequency is tuned
to the emergency frequency 121.500.
USR FREQ CYCLE BTN
Discrete input activates cycle through stored user COM frequencies.
STBY MONITOR BTN
Discrete input toggles Standby Monitor function.