190-01553-00
GTR 200/200B Installation Manual
Rev. P
Page 2-2
2.3.2 Optional Accessories
2.4 Installation Considerations
2.4.1 COM Antenna
A COM Antenna that meets TSO-C37( ) and C38( ) or TSO-C169( ), 50W, vertically polarized with
coaxial cable is recommended but not provided.
2.4.2 Installation Materials
The GTR 200/200B is intended for use with the standard aviation accessories. The following items are
required for installation, but not supplied:
• Wire (MIL-W-22759/16 or equivalent)
• Shielded Wire (MIL-C-27500 or equivalent)
• Hardware - #6-32 x 100° Flat Head SS Screw [(MS24693, AN507R or other approved fastener)
(6 ea.)] and #6-32 Self-Locking Nut [MS21042 or other approved fastener (6 ea.)]
• Push/Pull (that can be manually reset) Circuit Breaker
• Tie Wraps or Lacing Cord
• Ring Terminals (for grounding)
• Coaxial Cable (RG-400, RG-142B or coaxial cable with 50 Ω impedance meeting applicable
aviation regulations should be used.
Table 2-3 Contents of Connector Kits (011-03240-00/-01), see
Figure C-2
Item
Part Number
Quantity
Backshell w/Hardware, 37 pin
011-00950-03
1
Connector Plate
115-01879-00
1
Ring Terminal
117-00147-01
1
Single Coax Connector Plate Adapter
125-00165-00
1
Pan Head Phillips Screw 8-32 x .312
211-60209-09
6
Flat Head Phillips Screw 4-40 x .250
211-63234-08
4
Flat Head Phillips Screw 4-40 x .375
211-63234-10
4
Split Lock Washer, size 8
212-00018-04
6
Shoulder Washer
212-00022-00
1
Flat Washer #4
212-00024-04
1
Flat Washer, Inside Diameter 0.195”, Outside Diameter 0.354”
212-20065-00
6
Alignment Pin, Shoulder #4-40
233-00087-00
1
Male/Female BNC Connector
330-00053-01
1
37 Pin D-Sub Crimp Socket Connector
330-00625-37
1
Crimp Socket Contact, Size 20, 20-24 AWG
336-00022-02
37
Table 2-4 Optional Accessories
Item
Part Number
4 GB Micro SD Card (w/SD adapter)
010-10683-05
