Settings
16
GHC 10 Owner’s Manual
settings
You can customize system, remote control, and user settings.
system settings
From the heading screen, select
Menu
>
Setup
>
System
.
•
Units
—set the units of measure used to represent values displayed on the
GHC 10.
◦
System Units—
units used for every measurement displayed by the
GHC 10. You can select
Statute
(mi., ft.),
Metric
(km, m),
Nautical
(nm, ft.), or
Metric Nautical
(nm, m).
◦
Helm Displacement
—unit used for displacement volume of the
hydraulic steering pump, typically indicated on the helm. You can
select
Cubic Inches
(cu. in.) or
Cubic Centimeters
(cc).
•
Heading—
set the reference used in calculating heading information.
◦
Magnetic
—calculates the heading based on magnetic north.
◦
True
—calculates the heading based on true north.
•
Variance
—set the variance from true north. Variance is available only
when the Heading is set to
True
.
◦
Auto
—automatically determines the ideal variance setting.
◦
User
—you define the variance setting.
•
Beeper
—set whether the device makes sounds when you select a key or
when an alarm sounds.
◦
Alarms only
—beeps only when an alarm sounds.
◦
on (Keys & Alarms)
—beeps when you select a key and when an
alarm sounds.
•
Auto Power
—enables the device to turn on automatically when the
NMEA 2000 network turns on.
•
Unit Voltage—
the device displays an alert and sounds an alarm when
the battery reaches a specified voltage. When you select On, you must
specify the voltage at which the alarm sounds and the alert displays.
•
Language
—set the on-screen language.
•
operating Mode
—set the device to operate normally or in store
demonstration mode.
•
System Information
—shows the device ID numbers and software
information for the GHC and GHP.
•
Factory Defaults
—select Reset to restore the device to factory defaults.
gHC 10 remote settings
Connecting the gHC 10 remote
Before using the GHC 10 remote, you must connect the remote to the
GHC 10 and configure the settings.
You can connect one GHC 10 remote (optional) to a GHC 10.
1. From the Heading screen, select
Menu
>
Setup
>
Remote
.
2. Select
Search for Remote
, then hold the left and right double-arrow
keys on the remote. The autopilot to searches for and pairs with the
GHC 10 remote.
