190-02081-03
GFC 600H HFCS Part 27 STC Maintenance Manual
Rev. 3
Page 3-13
3.3.1 Software Loading
NOTE
Prior to performing any configuration or calibration steps, software must be updated on
each system component to match the versions specified in the Equipment List
(P/N 005-01095-01).
3.3.1.1 GMC 605H and GFS 83 Software Loading
Prior to configuration and checkouts, the GFC 600H software must be updated. Follow the instructions in
this section to load software to the GMC 605H and GFS 83 servos:
1. Go to the Garmin
and download the GFC 600H software as specified on
the Equipment List (P/N 005 01095-01).
2. Run the software image executable, loading the software to a USB flash drive.
3. Verify that there is no electrical power to GFC 600H system by pulling the FCS circuit breaker.
4. Connect the USB flash drive to the GMC 605H using a USB adapter cable (P/N 320-00726-01).
5. Start the GMC 605H in Configuration mode by applying power to the system while holding the
LVL
key on the GMC 605H.
6. Once powered, the system will provide an acknowledgment to enter Configuration mode. Select
the option to go into Configuration mode.
7. The
VS
and
IAS
keys navigate the cursor across the screen. Selected data is shown in reverse
video on the display. The scroll wheel navigates through selected pages/options.
8. Go to the
SYS > SW UPLOAD
page.
9. Select the SW Upload using the
VS
key. Use the scroll wheel to highlight SW Upload, and press
VS
to begin the software load.
NOTE
When the software upload process is complete, the GMC 605H will restart in Configuration
mode and “SOFTWARE UPLOAD SUCCESSFUL” should be displayed. If any errors
occur during the upload, view and record the software parts that did not load successfully.
10. After the GMC 605H shows that the initial software load is completed, select
Continue
. The GMC
will load additional software regions and reboot to the start-up screen.
Do Not Remove Power
.
11. Verify the version on the start-up screen matches the specified version listed on the Equipment
List.
12. Recycle power to the GFC 600H. Press and hold
LVL
to enter Configuration mode while applying
power to the system. Select the option to go into Configuration mode.
13. Go to the
PROD
page.
14. Scroll through each of the PROD pages and verify that all of the displayed software part numbers
and versions match the approved software part numbers and versions listed on the Equipment List
(P/N 005-01095-01).