Feeding the Cables Through the Shaft
1 Place the grommet nut over the transducer cable with the threaded side facing the downshaft adapter.
2 Feed the transducer cable a few feet into the shaft through the front hole of the downshaft adapter.
3 Bundle the power cables and feed them completely through the shaft with the transducer cable.
Installing the Nose Cone and Skeg
1 From the transducer replacement kit, select the cable grommet that fits your transducer cable:
• For a 4-pin transducer, select the cable grommet with the smaller hole.
• For an 8- or 12-pin transducer, select the cable grommet with the larger hole.
NOTICE
If you are not installing a transducer or are routing the transducer cable outside of the shaft, you must install the
provided grommet without a hole. Installing any of the other grommets without routing a transducer cable will
result in water ingress that may damage the motor.
2 Pull the transducer cable straight, and measure a 38 cm (15 in.) from the where the cable enters the
transducer.
3 Using a permanent marker, mark the measured location on the cable .
10