Garmin CS 1522, Owner'S Manual

Page: 17 / 74

1.4 Installation 15
If you are using a nut plate, the smaller hole on the nut plate should line up with the
smaller hole on the template.
12 If the smaller hole on the nut plate does not line up with the smaller hole on the
template, mark the new hole location.
13 If you are using a nut plate, drill a 3.6 mm (9/64 in) hole in the smaller hole location.
14 Repeat to verify placement of the remaining nut plates and holes on the template.
15 Remove the template from the mounting surface.
16 Starting in one corner of the mounting location, place a nut plate on the back of the
mounting surface, lining up the large and small holes.
The raised portion of the nut plate should fit into the larger hole.
17 Secure the nut plates to the mounting surface by fastening the included M3 screws
through the smaller 3.6 mm (9/64 in) holes.
18 Install the foam gasket on the back of the device.
The pieces of the foam gasket have adhesive on the back. Make sure you remove the
protective liner before installing them on the device.
19 If you will not have access to the back of the device after you mount it, connect all
necessary cables to the device before placing it into the cutout.
NOTICE
To prevent corrosion of the metal contacts, cover unused connectors with the
attached weather caps.
20 Apply marine sealant between the mounting surface and the device to properly seal
and prevent leakage behind the dashboard.
21 If you have access to the back of the device, apply marine sealant around the cutout.
22 Place the device into the cutout.
23 Secure the device to the mounting surface using the included M4 screws .
24 Wipe away all excess marine sealant.
25 Install the trim caps by snapping them in place around the edges of the device.