Garmin G5 User's Manual
190-02072-00 Rev. B
3
Installation Manual
Installation Manual
Pilot's Guide
Index
1.1.4.3 OPTIONAL GARMIN LRUS
The G5 can be installed in a standalone configuration or as part of the G3X system.
Optional Garmin LRUs (Line Replaceable Units) that can be installed with the G5 in the
standalone configuration are listed below. If any of these LRUs are to be used in this
installation, verify that all required installation materials such as connector kits have
been acquired. Refer to the G3X Installation Manual (190-01115-01) for additional
installation information for these LRUs and for the G3X system.
Optional Garmin LRUs:
• GAD 29 ARINC 429 Adapter
• GMC 305 Mode Controller
• GMC 307 Mode Controller
• GSA 28 Servo Actuator
1.1.5 REQUIRED NON-GARMIN EQUIPMENT
1.1.5.1 WIRING/CABLING CONSIDERATIONS
The installer will provide all wiring and cabling unless otherwise noted.
1.1.5.2 CONTACT AND CRIMP TOOLS
Table 1-2 lists recommended crimp tools used to build the wiring harnesses for the
G5, other equivalent tooling may also be used.
Table 1-2 Pin Contact and Crimp Tools Part Numbers
Contact Type
Garmin Contact
Part Number
Recommended
Positioner
Recommended
Insertion/
Extraction Tool
Recommended
Hand Crimping
Tool
Socket, Size 20,
20-24 AWG
336-00022-02
M22520/2-08,
Daniels K13-1
M81969/1-04 for
size 22D pins and
M81969/1-02 for
size 20 pins
M22520/2-01
NOTE:
Non-Garmin part numbers shown are not maintained by Garmin and
consequently are subject to change without notice.
