Part # 4517125 (09/03)
Page 22
6. Use or to change the Probe Calibration to the
correct temperature measured with a pyrometer.*
SEE
CALIBRATION REQUIREMENTS
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
SYSTEM SETUP”
9. Press again to exit.
To Change Probe Calibration - Grill:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” is displayed.
5. Press five, (5), times. “PROBE CAL – GRILL
XXXF” will be displayed.
6. Use or to change the Probe Calibration to the
correct temperature measured with a pyrometer.*
SEE
CALIBRATION REQUIREMENTS
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
SYSTEM SETUP”
9. Press again to exit.
*CALIBRATION REQUIREMENTS
The control software will beep to the user when it
is appropriate to calibrate. The control will allow
calibration provided the following conditions are
met:
• Temperature is currently falling from a detected
peak of 360°F or higher.
• Temperature is falling and has fallen 2°F from a
detected peak that is within the 350-360°F range.
(i.e. calibration would be allowed at 355°F if the
achieved peak temperature was 357°F)
PROGRAMMING continued
• Temperature is rising through the 350-360°F
range as a result of a heat on pulse of less than 30
seconds.
To Change Platen Set:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” will be displayed.
5. Press
six, (6) times. “PLATEN SET +/- XX”
will be displayed. (numbers will vary by grill)
6. Use
and
to change the Platen Set to the
correct value.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
MENU ITEMS”
9. Press again to exit.
To Change Instant-On Time:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” will be displayed.
5. Press seven, (7) times. “INSTANT ON TIME
XX:XX” will be displayed. (numbers will vary by
grill).
