![background image](http://html1.mh-extra.com/html/garland/ultimate-315-e-v15/ultimate-315-e-v15_instruction-manual_3632585030.webp)
English
30/104
Use this machine only for its proposed work. The
use of this machine for other jobs not stipulated in
this manual is dangerous and could cause injuries/
damages to the user and to the machine.
Do not use this machine if tired, ill, if under the
influence of medicines, alcohol or drugs.
Pay particular attention when using this machine as
the floor will be wet and there is an obvious danger of
slipping.
Do not use the machine if dark or with reduced
visibility as the work area will not be fully visible.
Lack of sleep or fatigue can cause damages and
accidents.
Limit your work time to ten minute periods with a rest
break between a further ten to twenty minutes.
Never leave he machine unattended.
Do not allow anybody into the work area. The work
perimeter should never be less than 15 meters.
Anything less is considered dangerous.
Hold the handle of the machine firmly to reduce the
risk of lack of control over the machine.
Only use original accessories and spare parts or
those recommended by the manufacturer. Otherwise,
damages and/or injuries to machine and user could
happen.
Whilst working, hold the gun with both hands.
If a work pause superior to 2 minutes is done, stop the
engine by placing the switch in the ¨o¨ position.
NOTE: This machine has a thermal sensor that
protects the engine in case of an overload. If the
thermal sensor is activated, the machine will stop and
will only start again after a few minutes.
Cleaning:
To clean, hold the gun with both hands and direct the
high pressure water to the objects to be cleaned. Do
not get too close to the objects as you could damage
these. We recommend maintaining always a minimum
distance of 30cm. From the objects being cleaned.
There are two lances, a standard lance and a rotating
lance. Use the rotating lance for those jobs where a
high pressure is needed. Use the standard lance for
those jobs that where you want to move dirt from one
place to another or where a moderate cleanliness is
needed.
The standard lance can be regulated to two positions.
The standard lance has two positions. The high
pressure fan position which can be regulated by
rotating the point of the lance. The more you open this
position, the pressure will be decreased.
The pressure regulation is adjusted for the following
uses:
- High pressure for cleaning.
- Low pressure for applying
soap.
Soaping:
6. USAGE OF THE MACHINE
Regulation of the angle of the spray
Pressure regulation
Summary of Contents for Ultimate 315 E-V15
