![background image](http://html1.mh-extra.com/html/garland/ultimate-315-e-v15/ultimate-315-e-v15_instruction-manual_3632585031.webp)
English
English
31/104
Please use exclusively GARLAND detergents
and care products.
Danger
The use of wrong detergents or chemicals can
compromise the safety of the appliance.
The use of other detergents and care products may
lead to premature wear and can invalidate your
warranty claims.
Danger
The improper use of detergents can cause severe
injuries or toxication.
When using detergents, the material data safety
sheet issued by the detergent manufacturer must
be adhered to, especially the instructions regarding
personal protective equipment.
Fill the detergent deposit with a neutral soap. Place
the standard lance in the open low pressure position
and action the trigger. The soap will mix with the water
creating abundant soapiness.
6.1. STOPPING USAGE OF THE MACHINE
Do not unscrew the high pressure hose straight
after stopping usage.
When not pressing the trigger
of the gun, there will be water from the pump to the
gun which will make unscrewing the connectors
practically impossible straight after use and if you do
manage to unscrew these, there will be danger of
injury.
When stopping use:
1. Place the switch in the ¨o¨ position.
2. Close the winter intake tap.
3. Press the trigger of the gun until water stops
coming out from the tip of the lance.
4. Disconnect the water intake hose of the machine.
5. Connect the machine again by placing the switch
in the ¨1¨ position.
6. Press the trigger of the gun again so that all the
water inside the machine empties. This only lasts
a few seconds. Do not maintain the trigger pressed
further as you could work in dry conditions and
damage the pump of the machine.
7. Disconnect the machine again by placing the
switch in the ¨o¨ position.
8. Disconnect the cable from the mains.
9. Tidy up and place the electric cable on its support
as well the high pressure hose and gun to avoid
accidents.
7. MAINTENANCE AND SERVICE
The removal of security devices, inappropriate
maintenance or the substitution of parts by non
original parts could cause severe injuries.
Always do maintenance work with the machine
unplugged from the mains.
The following maintenance work should be
done once you have finished working with
the machine to ensure a proper and adequate use the
following time the machine is used:
- Clean all the connectors.
eliminating any existing dirt.
- Clean the detergent deposit.
- Clean the lance with the
wire supplied with the machine.
- Clean the entry filter (5a) situated between the
water hose connector and the machine.
Summary of Contents for Ultimate 315 E-V15
