![background image](http://html1.mh-extra.com/html/garland/mule-561-qg-v20/mule-561-qg-v20_instruction-manual_3653741041.webp)
English
English
41/160
6.4. START-UP
6.4.1. CHECKPOINTS BEFORE COMMISSIONING
Do not use machine is if it is damaged or
incorrectly regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user, for the machine and for persons, animals and
things that may be around.
Check:
- The machine completely and look for loose and
damaged parts (screws, nuts, etc.).
- That the moving parts of the machine are not in
contact with any object.
- That the guard is properly attached to the machine.
- That the cutting tool is disengaged (see 6.4.1.1.)
- That there are no fuel leaks.
- The crankcase oil and transmission level.
- The air filter is clean.
Tighten, repair or replace everything you need before
using the machine.
Do not use any accessory on this machine outside of
those recommended by Garland since its use could
result in serious injury to the user, machine, and the
people, animals and things close to the machine.
6.4.1.1. CLUTCH CHECKPOINT
The cutting tool should be off by default to prevent
the machine from moving at the time of starting the
machine. To verify that the clutch is disengage, place
the switch to “STOP” position and pull slowly and
forcefully from the Starter handle the engine turn. Note
If, while the motor spins, also turn the cutting tool. If the
cutting tool rotates, it means that the clutch is engaged
and is therefore poorly regulated. If the clutch is not
correctly regulated take your machine for service.
6.4.2. STARTING THE ENGINE
Start the engine carefully, in accordance with the
instructions, and feet away from the milling cutters.
6.4.2.1. COLD-STARTING THE ENGINE
Place the machine on a flat
surface and stable to start it.
- Place the throttle lever in the
closed position .
- Place yourself behind the
machine, as shown in the
figure, and pull the starter rope
until the engine starts.
- If the machine starts and does not stop, slowly
begin moving the accelerator toward the Open air
position .
- Adjust the appropriate number of revolutions with
the throttle lever.
- Allow the engine to warm up for a few minutes
before starting to use the machine.
6.4.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat surface and stable to start it.
- Place the throttle lever in the position
.
- Place yourself behind the machine and pull the
starter rope until the engine starts.
- Adjust the appropriate number of revolutions with
the throttle lever.
STOP
Summary of Contents for MULE 561 QG-V20
Page 53: ...English 53 160 NOTES ...
Page 157: ...ελληνικά 157 160 NOTES ...
Page 158: ...ελληνικά 158 160 NOTES ...
Page 160: ......