![background image](http://html1.mh-extra.com/html/garland/mule-561-qg-v20/mule-561-qg-v20_instruction-manual_3653741044.webp)
English
44/160
7.2.1. USING SUGGESTIONS
A depth of tillage between 15-20 cm is generally
adequate, and rarely there is advantage in deeper. The
shallower tilling is frequently recommended for areas
of little rainfall to conserve moisture.
Secondary tillage is less shallow than the principal,
making 2 cross-styled passes on the terrain is
enough.
8. MAINTENANCE AND SERVICE
Perform regular inspections of the machine in order
to ensure efficient operation of the machine. For
complete service maintenance, we recommend to
take the machine to your service technician.
Before performing any maintenance or repair on the
machine make sure that the engine has stopped and
remove the spark plug pipe.
Only perform machine maintenance with the machine
on a flat, cleared surface.
WARNING! Do not modify the machine
or cutters. Improper use of these elements
can cause SERIOUS PERSONAL DAMAGE OR
DEATH.
Use only suitable replacement for this machine in
order to obtain a proper performance of the machine.
This replacement can be found in the official
distributors of the machine. The use of other spare
parts can cause risks, damage to the user, people
around and the machine.
Do not adjust the carburetor. If necessary, take your
machine in for service. Carburetor adjustment is
complicated, and only the technical maintenance
service must do them. Incorrectly setting the carburetor
may cause damage to the engine and will be cause for
cancellation of the warranty.
Removing the security devices, improper
maintenance, or replacements with non-original spare
parts can cause injury.
8.1. MAINTENANCE AND CARE AFTER USE
Perform the following maintenance operations
and care when you have finished working with
the machine to ensure the smooth running of this
machine in the future.
8.1.1. GENERAL CHECKPOINTS
Make sure the milling cutters are securely attached
to the transmission. If necessary, tighten the milling
cutters. Check the edge of the cutter and state of
the milling cutters. Replace the milling cutters when
necessary. It is recommended that these operations
are carried out by an authorized service technician.
8.1.2. CLEANING
Keep the machine clean, especially the area of the
fuel tank and areas close to the air filter.
Warning! The milling cutters are sharp and may
cause damage. Wear protective gloves when cleaning
the machine.
Cleaning the milling cutter area:
- Stop the engine and allow the engine to cool.
- Remove dirty and brush remnants using a scraper
and brush.
- Once you have removed the remains, you can use
a stream of water for a more thorough cleaning.
Summary of Contents for MULE 561 QG-V20
Page 53: ...English 53 160 NOTES ...
Page 157: ...ελληνικά 157 160 NOTES ...
Page 158: ...ελληνικά 158 160 NOTES ...
Page 160: ......