Garland Moisture+ MPOE5L, Installation And Operating Instructions Manual

Page: 15 / 16

Part # 4518084 Rev. 1 (09/04) Page 15
CLEANING AND MAINTENANCE
Oven Cleaning
Interior
• NOTE
: Disconnect the oven from the power supply
before cleaning or servicing.
• Establish a regular cleaning schedule. Any spills
should be wiped off immediately.
Tools:
Supplied spray hose; brush; cloth
• NOTE : The spray hose connection is located behind
the front control panel. When cleaning the oven
interior, attach the supplied hose to the water connector
behind the control panel.
1. The oven should be allowed to cool sufficiently
before beginning the cleaning procedure.
2. Remove the racks, rack guides, and the baffle. Wipe
each with a clean, damp cloth.
3. Using the supplied spray hose, spray the inside of
the oven lightly to remove any deposits.
4. Wipe the interior with a clean damp cloth to remove
any remaining deposits and spots.
5. Brush the wheel as needed to remove any grease
and/or particles.
6. Carefully wipe the blower wheel and temperature
probe with a clean damp cloth.
7. Replace the baffle, rack guides, and racks. Return
the spray hose to its storage compartment.
Motor Care
• The motor in this convection oven is maintenance
free since it is constructed with self-lubricating
sealed ball bearings. It is designed to provide durable
service when treated with ordinary care. There are a
few suggestions to follow on the care of the motor:
• When the motor is operating, it cools itself
internally by air entering at the rear of the motor
case, provided proper clearance has been allowed.
• Since the blower wheel is in the oven cavity, it is
at the same temperature as the oven. If the motor
is stopped while the oven is hot, the heat from the
blower wheel is conducted down the shaft and
into the armature of the motor. This action could
shorten the life of the motor.
• It is recommended that at the end of a bake or
roasting period, when the oven will be idle for any
period of time or before shutting down completely,
the door be left open slightly and the “ON/OFF”
button pressed to put the oven into Auto Cool
Down. Once the internal temperature of the oven
falls below 150°F (66°C), the fan will stop running
and the display will show “OFF”. This feature
protects the oven motor from pre-mature failure.
Optimal cool down will be achieved with the door
open slightly.