![background image](http://html1.mh-extra.com/html/garland/mealstream-ctm3/mealstream-ctm3_service-manual_3727364039.webp)
Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 39
M5 nut runner
Tools required for replacing hot air motor assembly.
Please Note
DO NOT attempt to carry out the following procedure
unless you have the following part and tools.
PROCEDURE FOR REPLACING HOT AIR MOTOR ASSEMBLY
Parts required for replacing hot air motor assembly.
Item Description
Part Number
Quantity
1
Hot Air Motor Assembly
11C0312
1
1.
Disconnect or isolate Oven from mains supply.
2. Remove
outer
covers.
3.
Remove shelf runners and element cover plate (See page 37).
4.
Remove fan blade securing nut and remove fan blade.
5.
Disconnect motor connection at terminal block.
(Note: which wire colour goes to which terminal).
6.
Disconnect Motor Earth tag then undo all securing nuts from the
motor mounting plate and remove the fan motor assembly.
7.
Check the position and condition of the hot air motor damper/seal
(this a important microwave leakage seal) in the motor shaft screen.
(See page 17).
8.
Fit new hot air motor assembly, and fit all securing washers and
nuts, ensure it is aligned centrally into the hole in the cavity, and
tighten all securing nuts. Make sure the ground wire is connected.
9.
Reconnect motor connection at terminal block.
(Note: correct position of each wire colour).
10. Refit fan blade and fan blade securing nut, and
ensure that the fan/
motor rotates free by hand.
11. Refit shelf runners and element cover plate.
12. Perform Microwave Leakage procedure (see pages 22-23),
checking carefully around the hot air motor assembly at rear of
oven.
13. Replace outer covers and fully test oven.
Fan blade securing nut
Fan blade
Summary of Contents for Mealstream CTM3
Page 1: ... 84 FGE84 I8AF G B 3 FFH8 4 8 0 84 FGE84 2 ...
Page 44: ...Mealstream Ovens Pt No 32Z3403 Issue 16 Page 44 CIRCUIT DIAGRAM ALL MODELS ...
Page 55: ......
Page 56: ......