-11-
090908_Instructions for use RTCS Base- and Wok-Line_E.doc
3.6
SH/WO 3500, SH/WO 5000 and SH/WO 8000
3.7
Installation
The cooker must always be set up on a clean and even surface (table, base, etc.) at it’s
designated site. The cooker stands on non-slip rubber pads and is not permanently installed. It
must be set up in a way that it cannot fall down or move in an uneven position. The conditions
for the „place of installation" must be guaranteed.
CAUTION
If the voltage is wrong, the cooker can be
damaged.
The installation of the electricity must be fitted by approved installation contractors in
accordance with specific national and local installation in conformity with all safety
regulations. The warning signs and rating plates on the units must strictly be followed.
Check and ensure that the supply voltage and the line current matches the specifications given
on the rating plate.
Max. tolerance of supply voltage
+6/-10 %
Supply frequency
50/60 Hz
Turn control knob to off position („0“)
Connect the unit to the power socket
(The unit is delivered completely with mains cable and plug.)
The installation is now finished and an operating test must be done according to chapter 4.