Garland Best Keeper 140 DW-V20, Instruction Manual

Page: 32 / 124

English
32/124
Both to tighten and to remove
the cutting accessories, the
transmission must be locked,
inserting a wrench or screwdriver
through the hole in the
transmission and the notch in the
plate.
5.2.3. MOUNTING THE STEEL DISC
Insert notch plate (2) onto driveshaft with recess
facing up. Then fit the blade disc (17), pressure plate
(16) and (15) and tighten the nut (14)
5.2.4. CHANGING THE NYLON WIRE
Dismounting
1. To unscrew the bump head fully, introduce a
screwdriver on the coupling plate and the hole of
the transmission so as to block the piece. Unscrew
the bump head turning clockwise.
2. Unscrew clockwise the bottom part of the nylon
bump head.
3. Remove the bottom cover. Remove the empty nylon
charge and any remaining nylon thread.
Threading the new nylon
Cut approximately 4 meters of nylon thread. Hold the
both ends of the nylon thread, fold in two. Insert into
the nylon charger and coil both ends of the thread in
the same direction but each thread in its groove.
Mounting
1. Block both ends of the nylon thread in the two
grooves (B).
2. Reinsert the nylon charge back into place and
place the two extremes of the nylon thread in the
exit holes (A).
3. Pull each nylon thread until it is sticking out some
12 cm .
4. Mount the bump head by turning anticlockwise.
5.3. START UP
5.3.1. VERIFICATION POINTS BEFORE START-UP
The supply voltage and current must comply with the
indications on the nameplate. Before starting work,
always check that the machine is working properly
and that its operation is safe.
Do not use this machine if it is damaged or improperly
regulated.
Use this machine for the purpose for which it was
A B
B
A