BA-
45.01.0 • US •01/15
6-3
6.
Operation
Rinsing after machine has over sucked
After over sucking (liquids or mud have come into the
machine) proceed as follows:
Remove locking screw at the intake flange (dis
mount the pipe of the additional lubrication if
necessary)
Open the vehicle tank, so the machine can be
operated without vacuum or pressure
Switch machine on and with slightly reduced
speed, fill in approx. ½ Iitre petrol, diesel or a
diesel-oil-mixture through the bore hole in
the intake flange
Switch off machine, screw in the locking screw
and
maintain
pre-lubrication
according
section
Intermediate positions of the four-way
changeover valve are not allowed during
the rinsing. The dirt leaving the machine
through the discharge flange could get on
the suction side again.