STEP 6.
Insert a 1/8” hex wrench into the hole in the left side of the
compressor housing (See Fig. #4). Loosen the set screw in the eccentric.
Insert a 5/32” hex wrench into the right side of the housing and loosen
the clamping screw at the base of the connecting rod .
3
Eccentric
Set Screw
Access
Hole
Eccentric
Set Screw
Figure 4
NOTE: It may be necessary to in-
sert a flat tip screwdriver into the
slot in the base of the connecting
rod, and spread the base slightly,
in order to free it from the bearing
(See Fig. #5).
STEP 7.
Slide the bearing off of the
shaft, then pull the connecting rod
out of the top of the housing (See
Fig. #4).
Spread to release
loctite bond
Connecting
Rod
Set Screw
Access
Hole
Connecting Rod
Screw
Figure 5
Bearing
Bore