![background image](http://html1.mh-extra.com/html/gardner-denver/governor/governor_manual_3577470033.webp)
Page 33
13-17-625 v00
Figure 32: Legacy ES+ RS485 Communication Wiring to Governor Display
Alternatively, the 6-conductor cable can be used to connect the ES+ to the Governor display using
the RJ-12 connector shown below in GD Kit
324AUX6028
in
Table 5. Connect the cable between
the RJ-12 terminal breakout and Governor Display at the IF5 interface as shown in Figure 32
above.
The terminal breakout has a total of six terminals to wire into corresponding to the six wires on the
telecommunications cable connected to the ES+ controller. The signal pinout for this board will be
as follows: Pin 1: RS485 GND, Pin 2: RS485 +, Pin 3: RS485 -. Use a communications cable such
as 97J93 to wire from these terminals to the Governor controller on IF5. Connect a 6-wire
telecommunications cable between the ES+ controller on one of two RJ-12 jacks and the RJ-12
connector on the terminal breakout. Mount the terminal breakout board on the DIN rail in the ES+
compressor control box.
For installations with more than two units, the pigtail plug in one of the ES+ RJ-12 ports must be
disconnected on all controllers except the two at each end of the communications line. The order of
interconnection has no effect on the operation.
Summary of Contents for Governor
Page 42: ...Page 42 13 17 625 v00 NOTES...
Page 43: ...Page 43 13 17 625 v00 NOTES...