Gardner Denver Governor, Manual, Page: 34 / 44

Page 34
13-17-625 v00
Figure 33: RJ-12 to Terminal Breakout Connector (GD PN: TEN023981)
Gardner Denver provides a kit 324AUX6028 that includes all hardware required to add a machine
to a new or existing ES+ sequencing network. The parts list for 324AUX6028 is listed in Table 5 .
Table 5: 324AUX6028 Sequencing Kit
Part Number Description Quantity
24CA3403 PLUG-MODULAR SPC TA-30-6 2
97J49 WIRE #24-6/C FLAT SPC TXW6205-WF 10 FT
TEN023981 Breakout Terminal Block, DIN Rail Mounted, 2 Amp, 120 Volt 1
24CA3404 CRIMPING-TOOL 1
5.2 Communication Configuration
Next, configure the RS485 communications under the Communications Configuration page. ES+
sequencing requires a specific baud rate for communications, which will be set automatically after
selecting the sequence mode. ES+ sequencing can operate on both 9600 and 1200 baud as long
as all devices on the network are set to the same baud rate. Navigate to the communication settings
by selecting Menu, Settings, Configuration, and then Communication, as shown in Figure 34. Select
the RS485-0 tab then change the mode to
Sequence
– ES+.
The location of the ES+
communications is on the display.