13-17-621 Page 83
Table 36: Programmable I/O
Programmable I/O Settings
Setting
Sub-Menu
Short Description
Programmable I/O
The User can enable or disable and assign digital input
signals to available channels.
The User can enable or disable and assign digital output
signals to available channels.
The User can enable or disable and assign temperature
input signals to available channels.
The User can enable or disable and assign analog input
signals to available channels.
The User can enable or disable and assign analog
output signals to available channels.
Table 36 above lists the sub-menus of the
Programmable I/O
sections.
4.6.1 Digital Inputs:
The
Digital Input
tab lists 14 parameter settings and each can be assigned a channel based on their
position on the IO module. Figure 116 below shows the screen for the
Digital Inputs
. Next to each signal
name, there is an input box to set the channel value and a toggle to set the signal as
high
or
low.
Figure 116: Digital Inputs
The
Remote Halt
signal has been assigned to
Channel 5
and is an
Active Low
signal, for the example
above.
The
Remote Halt Enable
has not been assigned to
a channel, so it is set to ‘0’ or disabled. To activate the
Remote Halt Enable
, tap the input box to assign a channel. Now the user can toggle this signal as active
high or active low depending on the operating logic required. Refer Figure 117 and Figure 118 below.
