![background image](http://html1.mh-extra.com/html/gardner-denver/gd-2500q-quintuplex/gd-2500q-quintuplex_operating-and-service-manual_3660125011.webp)
300FWF996 Page 5
Fluid end component inspections should
be performed more frequently than every
six months if pressures above 2500 psi
are used in the discharge system or if
corrosive, abrasive, flammable or hot
(over 110º F) fluids are being pumped.
Proper stuffing box packing selection is
important for safe pump operation. Contact
a Gardner Denver service representative for
assistance in selecting the proper packing
before beginning operation.
Before starting the pump the first time, and
periodically thereafter check the pump,
suction and discharge system fastener
torque versus the values listed on page 35
to insure proper tightness. Over and under
torquing can damage threaded pipes,
connections and fasteners, which may lead
to component damage and/or failure.
Replace all components found to be
damaged or defective. On pumps equipped
with stuffing boxes, the gland must be
engaged by at least three (3) threads to hold
the discharge pressure of the pump.
DANGER
Do not attempt to service, repair or
adjust the plunger packing or other-
wise work on the pump while the unit
is operating. Shut off the pump drive
engine and relieve the fluid pressure
in the suction and discharge systems
before any work or investigation is
performed on the pump or pump
systems.
Block the crankshaft from turning and make
certain that all pump drive motor or engine
start switches or starter controls are clearly
tagged with warnings not to start the pump
while repair work is in process.
Whenever the pump is operating, continually
monitor the entire suction, discharge and
pump
lubricating
systems
for
leaks.
Thoroughly investigate the cause for
leakage and do not operate the pump until
the cause of the leak has been corrected.
Replace any parts which are found to be
damaged or defective. When a gasketed
joint is disassembled for any reason, discard
the used gasket and replace it with a new,
genuine Gardner Denver gasket before
reassembling the joint.
Due to the high working pressures
contained by the fluid end, discharge
manifold and discharge piping, welding on
these components is not recommended. If
welding on the discharge system cannot be
avoided, only experienced, qualified welders
should be used. In addition, the welded part
should be hydrostatically proof tested in the
shop with water or hydraulic fluid to one and
one half times maximum discharge system
working pressure, with no observable fluid
leakage, before the part is reinstalled in the
pump system.
In summary, high pressure fluid streams can
possess sufficient energy to cause personal
injury, death and/or equipment damage.
These results can occur either through
direct contact with the fluid stream or by
contact with loose objects the fluid stream
has propelled, if the pump system is
improperly
used,
or
if
the
fluid
is
misdirected, or allowed to escape from
defective
or
improperly
maintained
equipment.
FLAMMABLE, HOT, COLD OR
CORROSIVE FLUID PUMPING
DANGER
Extreme caution must be exercised
by trained and experienced operators
when
flammable,
hot,
cold
or
corrosive fluids are being pumped to
avoid personal injury, death an/or
equipment damage due to explosion,
fire, extreme cold or chemical attack.
Never operate a pump that is pumping
hydrocarbons or other flammable, hot, cold,
or corrosive fluids when any part of the
pump, suction system or discharge system
HALLIBURTON EXHIBIT 1013, Page 11